ianlloyd
Lapping the Back Markers
Posts: 932
|
Post by ianlloyd on Jul 28, 2011 10:13:27 GMT
I am sure this has been asked before but my memory on the outcome is vague (it's an age thing)
Motor Fans is what I refer to. Is it better for them to suck the hot air out of a motor or to blow cooler air in to the motor. Or indeed does it make no difference whatsoever?
I am sure there must be some technical wizard out there that has a really good answer ;D
|
|
|
Post by Dave Chamberlain on Jul 28, 2011 11:54:18 GMT
|
|
|
Post by Reality Racer on Jul 28, 2011 13:39:11 GMT
I recon blow. But make sure you have at least a couple of mm air gap between your fan & ESC
|
|
|
Post by chrishall1976 on Jul 29, 2011 23:15:29 GMT
what about both lol
|
|
|
Post by lesbaldry on Jul 30, 2011 11:44:08 GMT
I am sure this has been asked before but my memory on the outcome is vague (it's an age thing) Motor Fans is what I refer to. Is it better for them to suck the hot air out of a motor or to blow cooler air in to the motor. Or indeed does it make no difference whatsoever? I am sure there must be some technical wizard out there that has a really good answer ;D Personaly I dont believe motor fans do much good at all,You very rarely see one used on any of the top drivers cars.....Put it this way thrers no point in blowing a fan over the oven when the roast is burning...The damage is already been done to the internals,But for a speedo yes! as the heat sink is in direct contact with the fets(via a thermal paste) unlike a motors windings and insulation to the Can or in a brushed motor's case the air gap between the Com stack and magnets....if your motors getting hot then the speedo's profile is wrong or the gearing....just my thoughts
|
|