|
Post by mattsedgley on Aug 24, 2009 13:00:44 GMT
I recently picked up a rather lovely new lipo, however!
At present, one cell is registering as 4.10 and the other cell is registering as 4.20 a gap seemingly unachievable by my LiPo balance charger to rectify! Are there any top tips our there for getting the cells back into balance?
|
|
|
Post by lesbaldry on Aug 24, 2009 13:40:10 GMT
I recently picked up a rather lovely new lipo, however! At present, one cell is registering as 4.10 and the other cell is registering as 4.20 a gap seemingly unachievable by my LiPo balance charger to rectify! Are there any top tips our there for getting the cells back into balance? Discharge to 6v at about 10amps and recharge with balancer at 3amps....this worked with one of my packs. Some Lipo chargers may not start the charge if the voltage is this low..if not kick start the Lipo with a Nhims charge on low amps to 7v.....but take care!!!
|
|
|
Post by Reuben on Aug 24, 2009 14:07:00 GMT
Yeh I had this same issue with my 4000 pack. one was at 4.2 the other at 4.1. I discharged at maximum for Lipo on the BC6 (which was 0.9A) Took about 6hours discharging!! The balanced from flat at 1C. Both Cells are perfectly balanced now and not fallen out since
|
|
|
Post by mattsedgley on Aug 24, 2009 15:19:55 GMT
Cheers Guys!
|
|