|
Post by Josh Hedge on Sept 12, 2010 13:36:34 GMT
Just wondering what the droop, ride hight, camber and gearing for my cyclone should be? I will be using a gen 2 stock spec and losi 17.5 motor. Thanks
|
|
|
Post by Reuben on Sept 12, 2010 15:56:01 GMT
you probably want to start somewhere like 5.5mm ride height all round (ride height MUST be at least 5mm in the hall, so we dont wear out Carpet.)
Droop: 5 front, 4 rear Camber: 1.5 front, 2 rear
Gearing with stock spec I think was about 5.5.
I never did much indoor with the Cyclone, so thats only a partial guess and somewhere to start.
|
|
|
Post by Josh Hedge on Sept 13, 2010 7:15:33 GMT
Thanks reuben, can anyone verfiy the gearing?
|
|
|
Post by jonnyboy on Sept 13, 2010 16:15:49 GMT
i would say ride height 5,5 at front and 6 at the rear droop 6 at front and 5 at the rear camber 2 all round 1.5 block at front and hpi pink springs at the front ant sliver rear hope this helps as for gearing try at 6 and temp it
|
|
|
Post by mattsedgley on Sept 13, 2010 17:20:23 GMT
Thanks reuben, can anyone verfiy the gearing? Reuben's advice is good..
|
|
|
Post by Josh Hedge on Sept 13, 2010 17:42:01 GMT
Ok thanks again for the setup advice, ill get it sorted tonight, how did kenya go Matt?
|
|